THE FERRARI REPLY TO THE GERMAN CARS

Author

admin

Browse pages
Current page

1

Current page

2

Current page

3

Current page

4

Current page

5

Current page

6

Current page

7

Current page

8

Current page

9

Current page

10

Current page

11

Current page

12

Current page

13

Current page

14

Current page

15

Current page

16

Current page

17

Current page

18

Current page

19

Current page

20

Current page

21

Current page

22

Current page

23

Current page

24

Current page

25

Current page

26

Current page

27

Current page

28

Current page

29

Current page

30

Current page

31

Current page

32

Current page

33

Current page

34

Current page

35

Current page

36

Current page

37

Current page

38

Current page

39

Current page

40

Current page

41

Current page

42

Current page

43

Current page

44

Current page

45

Current page

46

Current page

47

Current page

48

Current page

49

Current page

50

Current page

51

Current page

52

THE FERRARI REPLY TO THE GERMAN CARS

A CLOSE-UP OF THE NEW TWIN-ENGINED ALFA -ROMEO DESTINED TO RACE AT TRIPOLI, TUNIS AND AVUSNUVOLARI DOES 212 M.P.H. DURING THE FIRST TRIALS.

ON the 16th of December last the Scuderia, Ferrari celebrated its annual banquet, and talk naturally turned to the problem of challenging the new German cars. Signor Enzo and his colleagues realised that the 3-litre Type B Monoposto Alfa-Romeo, even when bored out to 3 2 litres and fitted with a specially streamlined body, could not hope to compete with the 4and 5-litre Merc6des-Benz and AutoUnions. What, then, was to be done ?

It was at this point that Signor Bazzi, technical director of the Scuderia, came forward with his idea of a solution to the problem. Briefly, this was to couple up a brace of 3-litre engines in a Monoposto chassis, and fit it with independent springing and a streamlined body. The result : a 225 m.p.h. motor car, eminently suitable for the non-formula races of Avues, Tunis and Tripoli.

Thus was born the Alfa-Romeo bimotore. Signor Bazzi, assisted by his able henchman, Signor Arnaldo Roselli, promptly got to work in his drawing office, and now, three months later, the actual car has been completed and made its first trials. Before going on to describe the layout of this remarkable car, it must be pointed out that although designated an Alfa-Romeo, all the work of its design and assembly has been carried out in the workshops of the Scuderia, at Modena. Signor jano has given it no more than his blessing. Truly might the bimotore be called a Ferrari-Alfa.

First of all, a Monoposto chassis was lengthened, but only by 15 cm., and into this were installed two Type 13 3-litre engines. The chassis members are of C section. In passing, these power units have 8-cylinders of 68 mm. bore and 100 mm. stroke, with a capacity for each engine of 2,905 cc. Thus the bimotore has a total cubic capacity of 5,810 cc. Each 3-litre engine gives 270 h.p., at its peak revs of 5,500 r.p.m. The power output is therefore about 90 h.p., per litre, as opposed to the 76 h.p. per litre of the German cars. Two Roots type superchargers are used on each engine, with twin Weber carburetters.

The front engine is situated in a normal position, while the rear unit occupies the centre of the triangle formed by the back axle and the two-propellor shafts, i.e., the position used for the driver’s seat in the 3-litre Monopostos. In the new car the driver sits on top of the gearbox, in between the. two engines.

The engines, are synchronised, the rear one being placed back to front and connected to the gearbox by means of internal gearing in its flywheel. The dry plate clutch is of unique design, and is constructed of Duralfa and Steel. The gearbox provides three forward speeds and reverse, all being of the constant mesh type. Outside the gearbox is an arrangement of dogs which disconnects the two engines to facilitate starting. First one and then the other is started up, and they are then coupled together. In the event of one engine giving trouble, it is possible for the

driver to continue at reduced speed on a single engine.

The differential is placed immediately behind the gearbox shaft, and consists of conical gears. The drive is then transmitted to the back axle by way of the usual twin propellor shafts, set at an angle. The rear axle is of special design jointed in the middle and steadied by radius rods which allow a certain amount of independent movement on the part of the two half axles.

The rear springs are semi-ellipties as heretofore, but with the addition of special shackles which give a floating effect. The front suspension is by the Dubonnet independent system, which incorporates oscillating arms and cylindrical coil

springs. Built in with the cylinders are two shock absorbers per wheel, one hydraulic and one friction. The advantages of the Dubonnet suspension, apart from the independent springing of each wheel, are firstly the reduction in unsprung weight and secondly, the stability of steering control due to the operating mechanism being securely attached to the chassis and therefore comparatively tree from road shocks. The brakes are of the Ariston hydraulic pattern, as described in ” Rumblings ” last month. Briefly, the chief feature is that all parts are kept under pressure from a special reservoir with a spring-loaded plunger, which prevents the possibility of air leaking into the piping when the brake pedal is released—an important advantage when braking from 200 m.p.h.! The Ariston brake system is the work of the Farina coach-building ,concern in

The large radiator is split into two sections, each of which cools an engine. The cooling of the rear engine is, of course, assisted by large air-ports in the tail. On each side of the chassis are slung

long petrol tanks, one for each engine, but inter-connected so as to ensure e’en balance. Sufficient fuel is carried for a run of 300 kilometres. A laige oil tank is carried in the tail.

The dimensions of the bintotore are as follow : Wheelbase 2,800 metres, track 1.380 metres, ground clearance 135 cm., maximum height from ground level 1.390 metres, overall length 4.160 metres, tyre sizes, front 19 x 5.50, rear 19 x 6.50, weight, 1,000 kilograms. This projectile was brought out for its first trial during last month. The Brescia-Bergamo Autostrada was used and the car was watched by a gathering of well-known personalities including Comm. Enzo Ferrari himself,

Comm. Vittorio Jano, technical director of the Alfa-Romeo Company, Cav. Perego, of the Pirelli Tyre Company, and various drivers such as Tadini and Comotti.

The first run was made by Attilio Marinoni, Chief mechanic of the Scuderia Ferrari, who satisfied himself that the car was functioning perfectly before handing it over to Tazio Nuvolari.

The ” Mantovano volante,” as he is dramatically called in Italy, made one or two runs up and down the autostrada at a a mere 175 m.p.h., or 4,500 r.p.m., in order to get assustomed to the feel of the car. At this speed the bimotore ran effortlessly, so he proceeded to give her the gun. The car roared past the little group of watchers at a colossal speed, which stop-watches and rev counter (which read 5,300 r.p.m.) showed to be 212 m.p.h.

When Nuvolari returned he was most enthusiastic about the car. Everything about it, he declared, was perfect ; the steering, the brakes, the road holding, and the vast reserve of power. He thinks there will be no difficulty in reaching the car’s maximum speed of 225 m.p.h.